Christie PowerTool User Manual download pdf (Page 34)

Section 4: PowerTool Interface

4-6 PowerTool 2.1 User Manual

020-100035-03 Rev. 1 (12-2010)

4.4.2 Control Tab

Figure 4-6 Control Tab

Information

These fields are disabled when multiple projectors are selected.

Projector Name – Identifies the selected projector by name. This is a

PowerTool reference only and is not stored on the projector.

Projector ID – Identifies the selected projector’s ID number.

Connection – Identifies the selected projector’s IP address/COM port.

Source

Auto Setup: – Optimizes settings for the current source. Auto Setup will

override settings you may have adjusted.

Table 4.1 outlines the Auto Setup

changes. PowerTool will prompt you to confirm that you want to use Auto

Setup. You must have an unlocked channel present to use Auto Setup. If

multiple projectors are selected, Auto Setup will be run on each selected

projector in succession. Failures will be reported. Auto Setup is not available

if the selected Input Signal source is inactive

Table 4.1 Auto Setup Settings

Pixel tracking Contrast

Pixel phase Brightness

Size and blanking Auto input level (Off)

Vertical stretch Detail (if video source)

Position Filter

Input levels Luma delay

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

No comments

Christie PowerTool User Manual Page 34