Christie PowerTool User Manual download pdf (Page 23)

The PowerTool Interface

Christie PowerTool 3.1 User Manual 13

020-100035-04 Rev. 1 (02-2014)

The Picture In Picture Pane

This table provides descriptions of the options available on the Picture In Picture pane:

Control Description

Picture in Picture Displays one image on top of the other and enables the controls.

This option is only available when there is an active signal and a test pattern is

not displayed.

Picture By Picture Displays two inputs side by side. The Size and Position controls are not

available.

Main Input Signal Sets the source for the primary input.

PIP Input Signal Sets the source for the PIP window. For a good quality image:

• Avoid using two sources from the same decoder.

• Use two different signal types if composite and S-video signals are on the

same decoder.

• Do not specify an interlaced source for the PIP window.

• Use a setting of less than 165 MHz when using two digital signals or a single

analog and digital signal.

• Use a setting of less than 90 MHz if you are using two analog signals.

• Avoid seamless switching when possible.

Swap Moves the main image to the PIP window and makes the PIP image the primary

image.

Preset Moves the PIP window to a preset position. These are the available options:

• Top Right

• Top Left

• Bottom Left

• Bottom Right

Select Custom to move the PIP window to a location you define.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

No comments

Christie PowerTool User Manual Page 23