Christie CP2000-X Setup Guide download pdf (Page 18)

2-6 CP2000 Setup Guide

020-100070-01 Rev. 1 (10/08)

Section 2: Installation and Setup

6. Power Cables to Head: From behind the main AC breaker panel (within the pedestal), connect

both identical power cables 34-001992 to the IEC receptacles located near Panel B (100-230 VAC)

and Panel C (200-230 VAC). These cables are interchangeable - connect either cable to either

receptacle and secure with metal strain-relief clip provided (Figure 2-7).

FIGURE 2-7 CONNECT “PROJECTOR” BREAKER POWER CABLES TO PROJECTION HEAD

IMPORTANT! Components in the lamp compartment will require 200-230 VAC.

NOTE: If you prefer to use an uninterrupted power supply (UPS) for supplying power to the

projection head, route the UPS power cables through the pedestal toe and connect to the IEC

receptacles on Panel B (100-230 VAC). In this case, only one power cable provided in the pedestal is

used.

Check Ethernet and TPC Power: Within the pedestal, confirm that the power supplies for the

Ethernet hub and TPC both connect to a power bar wired to the terminal block TB2 from either the

facility power source or the existing projector wiring (Figure 2-8). No other components or

external equipment should be connected here.

NOTE:

This is a current-limited 120 VAC outlet powered by the ballast and separately fused.

FIGURE 2-8 CHECK TPC AND ETHERNET HUB CONNECTIONS TO HUB

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 63 64

No comments

Christie CP2000-X Setup Guide Page 18