Christie CP2000-X Setup Guide download pdf (Page 54)

4-8 CP2000 Setup Guide

020-100070-01 Rev. 1 (10/08)

Section 4: Maintenance

3. Handling by the cathode end only, unscrew the lamp from the rear connector and carefully remove

from the projector. Immediately place the lamp inside the protective cover (saved from previous

installation) and seal it in a heavy carton on the floor where it cannot fall or be bumped.

4. With the lamp removed, visually inspect the reflector for dust. Clean if necessary, as described in

4.3

Maintenance and Cleaning.

REMOVE NEW LAMP FROM PROTECTIVE COVER

1. Remove tape, knurled nut and locking star washer (if present) securing the lamp within its cover.

2. Handling at the ends only, extract the lamp from the cover. Set aside the protective cover for re-use

in your next lamp disposal or for warranty return of an expired lamp.

INSTALL NEW LAMP

1. With protective clothing and shield on, insert the threaded cathode (-) end of the lamp into the

negative lamp connector nut located in the rear of the lamp compartment and screw in fully

(Figure 4-1 Install Bulb/Left). Hand-tighten only.

2. Rest the anode (+) end of the lamp on the lamp cradle (Figure 4-1 Install Bulb/Right) and slip the

positive lamp connector over the bulb end.

FIGURE 4-1 INSTALL BULB

WARNING

Handle box with extreme caution - the lamp is hazardous even when packaged. Dispose

of lamp box according to local area safety regulations.

CAUTION

Handle by the cathode/anode end shafts only, never the glass. Do not over-tighten.

Do not stress the glass.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 63 64

No comments

Christie CP2000-X Setup Guide Page 54