Christie DWX600-G User Manual download pdf (Page 43)

G Series User Manual

020-000648-01 Rev. 3 (02-2014)

Section 4: Operation

4-14

Manual Adjustment

1. Adjust color slide bars and judge image color by eye or meter. A user-

dened color “adjustment” can be applied.

2. Use this submenu if you do not have specic color coordinates in

mind and will judge color performance by eye or meter. As for Meter

Adjustment, each color control actually denes new x/y coordinates for

that color and changes its hue. The main colors (red part of red, green

part of green and blue part of blue) adjust the intensity of that color

component, while the modifying colors (e.g. green part of red and blue

part of red) modify the x and y value and change the hue of that color.

At the same time the main colors also are used to control the color of

the white point.

Hot-Key Settings

Assign a different function to the hot-key on the remote control by highlighting

the function in the list and pressing ENTER. Choose a function that does

not already have a dedicated button, and assign the hot-key to that function,

allowing you to quickly and easily use the chosen function.

Service

Projector Info: Display current projector settings (read-only).

Factory Reset: Restore all settings to their default value. It will not reset

network but it will reset RS232.

Test Pattern: Choose the desired internal test pattern to display, or select

OFF to turn off a test pattern.

Color wheel Index (2x): Set Color wheel index to Speed 2X. This setting

only needs to be used when the Main Board is changed, and should be

adjusted to optimize picture quality.

Color wheel Index (3x): Set Color wheel index to Speed 3X. This setting

only needs to be used when the Main Board is changed, and should be

adjusted to optimize picture quality.

Error log: Show the projector error log for debug.

Mode Adjustment: Fine tune the H and V start position for a signal in the

EDID timing table and record the values in the system to override the

timing table. The settings must be “Saved to Record” before exiting the

menu, or they will be lost. To revert to original timing table settings, each

setting must be manually cleared. Factory Defaults will not clear these

override settings.

Light Sensor: Calibrate the Light Sensor for use with the Constant Intensity

lamp mode, which allows the projector to be set for constant brightness. If

the Light Sensor has not been calibrated, Constant Intensity mode will be

disabled. Light Sensor calibration should be repeated when new lamps are

installed.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 95 96

Comments to this Manuals

No comments

Christie DWX600-G User Manual Page 43

Comments to this Manuals

Related products and manuals for Projectors Christie DWX600-G