Christie Christie HD User Manual download pdf (Page 105)

Section 3: Operation

M Series User Manual 3-55

020-100009-08 Rev. 1 (05-2013)

3.9.9 Frame Locking

When the selection is set to Frame Lock, output image frames are locked to the input. When locked, the

output is always locked to the primary input, never the secondary image. Select Free Run and this will set the

output to close at 60Hz for all sources.

NOTE: Seamless switching is only available when free run is selected. When switching to a new input with

frame locking enabled, the image will be black for the short period while the system locks onto the new input.

3.9.10Auto Input Searching

When enabled, the system will continually search for the next valid signal when no signal is present or when

loss of sync occurs on the current user selected input. In the case of multiple signals to choose from, the order

is based on slot, followed by inputs on that slot.

3.9.11HDMI Output Loop Source

Configure the HDMI output options.

Select Direct Loop to directly pass-through the HDMI input signals (from the same Twin HDMI Input Card).

The Input1 signal is looped to Output1 and the Input2 is looped to Output2.

Select Main/Secondary Loop to loop the Main and secondary video to the outputs (regardless of which card

these signal originate from). The Main video signal is looped to Output1 and the Secondary video signal is

looped to Output2.

Select Disable to shut off the HDMI outputs completely.

3.9.12Standby Active Loop-through

Enable this check box in situations where a Twin HDMI Input card is being used to loop signals out to another

projector. Standby Active Loop-Through ensures that video signals continue to be looped out when the

projector enters standby power mode.

NOTE: When the projector is in standby mode (and Standby Active Loop-Through is selected), limited

channel control is available - inputs can be switched, perform auto setup and some limited input settings can

be modified.

3.10 Status

The read-only Status menu lists a variety of details about the standard and optional components currently

detected in the projector. Refer to the Status menu for versions of hardware and software installed, the type

(size) of lamp, the hours logged in total and for a specific period (such as a rental period), and for your

projector model name and serial number. In addition, the Status menu identifies the current channel, its

location, its frequencies and other details.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 165 166

No comments

Christie Christie HD User Manual Page 105