Christie Christie HD User Manual download pdf (Page 33)

Section 2: Installation and Setup

M Series User Manual 2-15

020-100009-08 Rev. 1 (05-2013)

2.4.4 Stacking Multiple Projectors

NOTE: The projectors can be stacked and hoisted in either an upright or inverted positions.

1. With one person positioned on each side of the stacking frame, lift the

top stacking frame onto the bottom stacking frame, aligning all four

stacking legs between the frames.

NOTE: Remove the locking pin from each stacking leg prior to

alignment and ensure the four stacking legs are fully seated on the

lower stacking frame.

Step 2 is a critical safety procedure that MUST

be observed. Failure to engage the locking pin

may cause the projectors to separate, resulting

in possible injury or death.

2. Insert the locking pin through the holes in the stacking legs. Make sure each pin is fully inserted.

NOTE: The steel ball on the end of the pin keeps the pin from releasing inadvertently.

3. When required, repeat steps 1 and 2 for the third projector in the stack.

2.4.5 Stacking Alignment

Stacked projectors must be correctly aligned to one another so the resulting display is optimized. If hoisting the

stack, do so first and then align. To align the image, use pitch, yaw, or roll. Prior to aligning the image, turn the

locking nut to unlock then use the knob to adjust the image.

NOTE: Ensure to lock the locking nut to maintain the image adjustment.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 165 166

No comments

Christie Christie HD User Manual Page 33