Christie CP2000-X User Manual download pdf (Page 12)

PARTS & MODULE REPLACEMENT

CP2000-X Parts & Module Replacement

Gloves

Required

FANS (SIDE INTAKES)

(20 minutes each)

Two identical “intake” fans are mounted side-by-side on the lamp side of the

projection head. Although the filtered air actually enters on the opposite side of

the projector—the igniter side—these fans pull the air across the front area of

the projection head and are considered intake fans. Either fan can be replaced

independently after removing the louvered exhaust grille/shield from the

projector.

1) Remove projector front lid and exhaust grille. See Removing the Covers.

2) Make sure each fan harness is labeled

before disconnecting from the SSM (P2 and

P3). See Figure 13.

3) From outside, remove four corner 7/64” hex

mounting screws from the desired fan, and

remove the fan from the projector. See

Figure 15. below.

Figure 14. Side Intake Fans

4) When installing a new fan, finger-tighten only—do not over-tighten or

compress the rubber isolators.

FLEX CABLES

(10 minutes)

The 3 pairs of identical flex cables routed between the Enhanced Formatter

Interface Board (EFIB) and the light engine should be replaced whenever either

of these modules is replaced. The cables are available separately as well as with

the EFIB and light engine.

Figure 13. Side Intake Fans

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

No comments

Christie CP2000-X User Manual Page 12