Christie CP2000-X User Manual download pdf (Page 18)

PARTS & MODULE REPLACEMENT

CP2000-X Parts & Module Replacement

7) Tilt the LampLOC/duct assembly towards the rear of the projector. At this

point, the duct can be pulled

off the LampLOC module

and out of the projector

(Figure 24). It is a tight

fit—pull blower away for

better clearance.

8) Remove the LampLOC

module from the projector,

and swap in a new module.

After installation,

double-

check SDB connections, then

reset LampLOC.

LENS MOUNT

Refer to the CP2000/XP2000 Parts & Module Replacement Booklet

LIGHT ENGINE

Refer to the CP2000/XP2000 Parts & Module Replacement Booklet

LIGHT SENSOR MODULE

(10 minutes)

The Light Sensor Module (LSM) is located in the front corner of the projection

head, just above the SSM. To replace:

1) Remove the projector front lid. See Removing the Covers.

Figure 24. Tilt and Remove the Lamp

Cooling Compartment/LampLOC Assembly

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

No comments

Christie CP2000-X User Manual Page 18