Christie CP2000-X User Manual download pdf (Page 21)

PARTS & MODULE REPLACEMENT

CP2000-X Parts & Module Replacement 21

5) Remove four 5/32” hex screws securing the pump mounting bracket to the

base the projector. The interior screw nearest the heat exchanger is very

difficult to reach.

6) To remove the pump assembly,

tilt it toward the front and middle

of the projector—this may take

several tries, but the entire heat

exchanger/pump assembly can be

removed via the igniter door

opening.

Re-installation:

PROPER ROUTING TO LIGHT

ENGINE:

At the underside of

the projector, make sure to re-

connect the hoses correctly:

 Heat exchanger to red

(CP2000-X lamp side)

 Reservoir to blue

(CP2000-X air filter side)

FILLING: The system is

subject to air locks upon

filling, particularly if hose

lines are significantly curved.

For best results, fill before

securing the new cooling

system in the projector—

spread lines out as flat and

straight as possible before

adding liquid coolant.

Eliminate any air locks—

liquid must be continuous,

with no gaps or bubbles.

IF A SINGLE COOLING

COMPONENT WAS REPLACED:

To fill a system already installed within the

projector (for example, when you have replaced only the pump):

Figure 29. Cooling Components

Out

Figure 30. Proper Hose Reconnection

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

No comments

Christie CP2000-X User Manual Page 21