Christie LCD projector User Manual download pdf (Page 120)

7-8 CP2210 User Manual

020-100410-08 Rev. 1 (05-2014)

Section 7: Maintenance

7.11 Replace the Lens

1. Tap and hold the red power button on the TPC Main panel to turn the lamp and cinema projector off.

2. Allow the lamp to cool for a minimum of 10 minutes.

3. Unplug the cinema projector.

Figure 7-5 Lens Assembly

4. Install the lens cap and release the lens clamp by pushing it up (Figure 7-6).

Figure 7-6 Release Lens Clamp

5. If necessary, remove the 2 cap screws securing the lens to the lens mount (Figure 7-6). The cap screws are

only needed when the cinema projector is ceiling mounted.

6. Pull the lens out of the lens mount. The lens, motorized zoom and focus connectors disconnect when the

lens is pulled straight out of the mount.

7. Remove the small rear cap. Keep the front cap on.

8. Align the mounts on the lens connector with the lens mount. Insert the lens until it connects with the

magnets on the mount. Once the lens makes contact with the magnetic plates it will be seated correctly and

the connector for motorized zoom and focus will be properly connected (Figure 7-7).

9. Secure the lens clamp by pushing it down to the closed position.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 139 140

No comments

Christie LCD projector User Manual Page 120