Christie Christie HD Setup Guide download pdf (Page 14)

2-2 M Series Setup Guide

020-100011-06 Rev. 1 (05-2013)

Section 2: Installation and Setup

2. Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating

connector on the lens mount. Fully insert the assembly straight into the lens mount opening without

turning. Press using your hand as shown.

NOTE: When installing the lens, ensure that the lens is not inserted at an angle, as this can cause damage.

3. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens

assembly in place.

4. Remove the front lens cap.

5. For added stability such as motion applications, fasten the security screws provided with the lens-mount.

NOTE: There are two types of lens plate models.

6. Use a 5mm hex driver to fasten the red security screws provided with the lens mount, or hand tighten the

lens retaining screws attached to the lens.

NOTES: 1) Recommended for heaviest lenses such as 0.73:1 and 1.2:1. 2) The red security screws MUST

be installed when hoisting the projector overhead, or installing the projector in an overhead position.

Use of the lens red security screws or the lens retaining screws is required if

the projector is hoisted or installed in an overhead position.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

No comments

Christie Christie HD Setup Guide Page 14