Christie Christie HD Setup Guide download pdf (Page 27)

Section 3: Operation

M Series Setup Guide 3-5

020-100011-06 Rev. 1 (05-2013)

• Help Key: Only available in the On Screen Display (OSD) context; LED is Amber when the menu is being

displayed on the projected image display; when no menu is being displayed, the Help key is still enabled if

the OSD is enabled. It is only disabled when the entire OSD is set to OFF.

• Auto Key: Enabled state when the power is ON, and there are no test patterns on the screen. If the power is

OFF or a test pattern displays, the Auto key is disabled.

• Exit Key: Is determined in the specific context of the screen being displayed.

• Input Key: Enabled when the power is ON. Disabled if the power is OFF.

• Lens Key: Enabled when the power is ON. Disabled if the power is OFF.

• Shutter Key: Enabled when the power is ON. Disabled if the power is OFF.

• Menu Key: Always remains in the enabled state when the power is ON. If the power is off the Menu key is

disabled.

• Soft Key: Used to select an action indicated by text above the key on the LCD. If no text is shown, the

associated key is disabled.

3.1.6 Remote Keypad Commands

Specific keypad commands are explained in Table 3.1 M Series Key Commands.

Power ON/OFF

Press and hold POWER for two seconds or press twice quickly to action the projector ON or OFF. Or press and

release P

OWER followed immediately by the UP ARROW KEY (ON) or DOWN ARROW KEY (OFF) to

guarantee the correct action (useful if you are unsure of the present state).

NOTES: 1) After powering down, the lamp cooling fan remains on for approximately five minutes to cool the

lamp. 2) Avoid turning the projector back on until it has been off for a few minutes. Hot re-strikes of the lamp

will reduce lamp life and may cause the lamp to explode.

Test

Steps forward through all internal test patterns. After stepping past the last test pattern, you will return to

current input.

Press T

EST and then cycle by using the UP ARROW KEY and DOWN ARROW KEY arrow keys, to cycle in either

direction through the test patterns. Press E

XIT to return to the current input.

Auto

Initiates an automated process in which the projector optimizes critical display parameters such as size,

position, pixel tracking, etc., for the current source. These parameters are listed in the following table. An auto

setup can save time in perfecting a display and you can modify the adjustments as desired.

Table 3.2 Auto Setup

OPTIMIZES SETS TO DEFAULT

Pixel Tracking Contrast

Pixel Phase Brightness

Size and Blanking Auto Input Level (off)

Vertical Stretch Detail (if video source)

Position Filter

Input Levels Luma Delay

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 53 54

Comments to this Manuals

No comments

Christie Christie HD Setup Guide Page 27

Comments to this Manuals

Related products and manuals for Data projectors Christie Christie HD