Christie Christie HD Setup Guide Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 54
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
2-10 M Series Setup Guide
020-100011-06 Rev. 1 (05-2013)
Section 2: Installation and Setup
2.2.6 Projector Communications
Status LEDs
Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power, and
Status. The LEDs will display the colors as shown below:
PROJECTOR STATE LEDS LED STATE
Hard Boot All
All LEDs amber - means please wait
Standby Mode Lamp 1 and 2
Off - lamps are off
Power
Amber - AC is present but projector is off or
standby
Shutter
Green - shutter is open
Amber - shutter is closed
Warm-up (Powering ON from standby) All LEDs cycle green from left to right
Normal Operation Lamp 1 and 2
Amber - lamp time has expired and lamp should
be replaced
Power
Green - projector is powered up and operating
normally
Shutter
Green - shutter is open
Amber - shutter is closed
Cool-down All LEDs cycle amber from left to right
Error
Lamp 1 and 2
Amber - lamp time has expired and lamp should
be replaced
Flashing Red - lamp has malfunctioned
Power
Flashing Red - error has occurred. Details are
displayed on the status display
Software Upgrade in progress All The pattern will alternate between:
Amber and Off
Lamp Regeneration in progress Lamp 1 and 2
Flashing Green - the lamp is being switched
off for its regeneration period to extend lamp life
(typically 15 minutes every 24 hours)
Power
Green - on
-OR-
Amber - standby
Shutter
Green - shutter is open
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
The Status LEDs are cycling green
The LCD displays the warning “Image Processor Upgrading”
The LED on the Image Processor card flashes green
The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Comments to this Manuals

No comments