Christie PowerTool User Manual download pdf (Page 22)

Section 3: Working with PowerTool

3-4 PowerTool 2.0 User Manual

020-100035-02 Rev. 1 (03-2010)

• Listed projectors that are not responding to Ethernet communication

will be noted with a COMM ERROR warning.

A COMM Error may indicate:

• The wrong port has been specifi

ed for the projector(s).

• Network traffic may be high.

• The projector may not be working properly.

NOTE: Auto detection may fail if some of the projectors have duplicate IDs

or IP addresses. If no projectors are found, your router and/or firewall may

not be configured correctly. If some projectors are found and others are not,

you may have problems with one or more of the following: duplicate IDs or

IP addresses, incorrect IP addresses, or incorrect firewall configuration.

3. Click Se

arch. PowerTool detects all the projectors that are connected.

Figure 3-6 Projectors found

NOTE:

Projectors flagged with the message “COMM ERROR” have been

detected, but are not responding to communication. They cannot be selected

for configuration until the communication problem has been resolved.

4. Click to select the projector(s) and Click a selecte

d projector to deselect

it, or click Deselect All to clear your selection.

5. Click Nex

t to add the projectors to the configuration. Projectors are

added in the order they are selected.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

No comments

Christie PowerTool User Manual Page 22