Christie PowerTool User Manual download pdf (Page 29)

Section 4: PowerTool Interface

PowerTool 2.0 User Manual 4-3

020-100035-02 Rev. 1 (03-2010)

Control Panel

Input Signal – Sets the input source for the selected projectors. If

multiple projectors are selected, only the sources that are common to all

the selected projectors are included in the list. See the projector manual

for information about supported input sources.

Test pattern – Identifies the test pattern to display during setup or

troubl

eshooting. This option is enabled for supported projectors only.

Enable – When checked enables the selected test pattern on the

selected projector(s

). The test pattern displays instead of the media from

the input source.

NOTE: If multiple projectors are selected and only some of them are

shuttered, the check box remains unchecked.

Shutter Open – Opens and Closes the shutter for the selected

projecto

r(s).

Layout Panel

Polling Rate – Sets the rate at which PowerTools sends a status

req

uest to all the projectors in the configuration. This setting should

only be changed by experienced system administrators. The polling rate

for serially connected projectors should not be set lower than 300.

Layout – Select the layout of the projectors in the con

figuration.

PowerTool calculates layout options based on the number of projectors

in the configuration. The selected layout is reflected in the projector

workspace below the tool bar.

Add Devices – Opens the Add Devices dialog.

Launch – Opens the virtual remote keypad so that you can

control the

selected projector using the familiar keypad layout.

4.4 Projector Workspace

Figure 4-4 Projector Workspace

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

No comments

Christie PowerTool User Manual Page 29