Christie CP 2210 User Manual download pdf (Page 54)

5-6 CP2210 User Manual

020-100410-07 Rev. 1 (01-2012)

Section 3: Operation

3. Tap OK.

4. Adjust the focus, Horizontal (X) and Vertical (Y) offset, and zoom by tapping the applicable button.

NOTE: This does not over-write the system settings for the ILS. If

Enabled Automatic ILS is selected again,

the ILS will position the lens to the saved channel settings.

5. If the

Quick Reset or Lens Calibration buttons are tapped in the Advanced Setup: Lens Setup window, the

lens returns to this remembered location. Also, this setting is remembered across system resets and reboots.

5.6.5 Reset the ILS

The ILS must be reset when:

• the lens has been moved

• manual adjustments have been made to horizontal or vertical offset, zoom or focus

• a power outage occurred during a channel change

• ILS settings are drifting within a short period of time

1. On the Main screen of the TPC, tap Lens Adjust.

2. Tap Quick Reset. If Enable Automatic ILS is not selected, the lens returns to the stored settings.

5.6.6 Calibrate the ILS

You must calibrate the ILS must when you install a new lens.

1. On the Main screen of the TPC, tap Lens Adjust.

2. Tap Full Calibration. If Enable Automatic ILS is not selected, the lens returns to the stored settings.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 163 164

No comments

Christie CP 2210 User Manual Page 54