Christie RPMX-D132U Setup Guide download pdf (Page 15)

RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 2-1

020-100246-02 Rev. 1 (10-2010)

2 Installation and Setup

The following instructions are for those preferring a quick setup. Refer to the remaining subsections for

detailed set instructions.

2.1 Projector Quick Setup and Installation

This section outlines the installation sequence of an RPMX/RPMSP-D132U or RPMSP-D180U projector as a

stand alone or multiple projector installation.

If you are installing your projector in a TotalVIEW 50”or 67” cube enclosure, refer to the separate

installation guide provided (020-100248-XX)

Step 1 Unpacking the projector

The projector is shipped fully assembled in the lens-vertical (90 degree) configuration. After receiving your

projector it is important that you prepare it for installation by:

Removing the projector from the box and discarding any packing material surrounding the modules.

NOTE: An L-shaped bracket, used to change the projector’s configuration, is shipped loosely in the box with

the projector. Set this aside for future use.

Verifying all cable connections are secure. See

Figure 2-1.

Check lamp handles. These handles must lay flat against the lamp surface otherwise they will interfere

with lamp operation.

FIGURE 2-1 INTERNAL CABLE CONNECTIONS

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 15