Christie RPMX-D132U Setup Guide download pdf (Page 21)

Section 2: Installation and Setup

RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 2-7

020-100246-02 Rev. 1 (10-2010)

NOTE: For more information on the keys available on the remote and their function, refer to Section 3

Operation.

NOTE: The projector enforces a 60 second wait period from the time the projector is powered down and back

up again.

Step 6 Adjusting the projection lens

FIGURE 2-9 LENS ADJUSTMENT HANDLE

1. Loosen the adjustment handle (turn thumbwheel) on the lens barrel.

2. When the image is focused, lock adjustments in place by tightening the adjustment handle until just tight.

Lock lens adjustments to prevent unnecessary tampering.

Step 7 Adjusting image geometry using the 6-axis adjuster

The light engine is mounted to the 6-axis adjustment mechanism, which can fine-tune the geometry of a

displayed image by moving the light engine about the X, Y and Z-axes in varying degrees.

For single projectors, adjust the 6-axis adjuster until the displayed image fills the screen and appears without

any geometric distortion.

For a multi-projector display wall, use the 6-axis adjuster to closely match the image across multiple screens.

You should begin adjustment on an end unit on the bottom row of wall and work your way across and up until

all units are adjusted.

To adjust the 6-axis adjuster:

1. Center the image on screen, by adjusting vertical and/or horizontal position.

2. Zoom the image out (make smaller) until it fits within the borders of the screen.

3. Adjust keystone and tilt.

4. Zoom the image in (make larger) to fill the screen.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 21