Christie RPMX-D132U Setup Guide download pdf (Page 27)

Section 2: Installation and Setup

RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 2-13

020-100246-02 Rev. 1 (10-2010)

Connecting RS-422

To control the projector with a computer or other devices with RS-422 capability, connect an RS-422 serial

communication cable between the computer and the RS-422 port on the projector. RS-422 is better suited for

serial communication over long distances than RS-232 communication.

Use the RS-422 port only if your device has RS-422 capability. Consult the literature provided with your

equipment before connecting. Connecting to the RS-422 port with incompatible equipment could damage your

projector.

FIGURE 2-18 CONNECTING RS-422

2.3.3 Ethernet Communications

To add the projector to an existing Ethernet network, connect standard CAT5 Ethernet cable between your

Ethernet hardware and the Ethernet port on the side of the projector.

The project factory default is DHCP enabled, an IP address will be ob ta i ed automatically. If there is no

DHCP server available on the network or if a static IP address for the projector is required, set the address in

the Ethernet Settings menu or via serial command.

Regardless of how it is assigned, once a projector has a valid and unique address it will respond to commands

sent to this address. To determine the projector’s current IP address, consult the Status or Communications.

Refer to the user manual for further information about setting up and using a projector connected via Ethernet.

FIGURE 2-19 ETHERNET COMMUNICATION

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 27