Christie RPMX-D132U Setup Guide download pdf (Page 47)

RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 4-1

020-100246-02 Rev. 1 (10-2010)

4 Maintenance

4.1 Projector Location

Operate the projector in an environment, which meets the operating range as specified in Section 6 – Specifica-

tions.

• Do not operate the projector close to water, such as near a swimming pool. Do not operate in extremely

humid environments.

• Do not place the projector on an unstable cart, stand or table. A projector and cart combination should be

used with care. Sudden stops, excessive force and uneven surfaces may cause the projector and cart com-

bination to overturn.

• Do not ceiling mount this projector.

4.2 Ventilation

Slots and vents in the projector provide ventilation to ensure reliable operation and prevent overheating. Do

not block or cover these openings.

• Do not place the projector over a radiator or heat register.

• Do not place the projector in an enclosure without proper ventilation.

• Do not “poke” objects into the ventilation openings of the projector. They may touch dangerous voltages or

short-out components resulting in a fire or shock hazard.

• Do not spill liquids into the projector. If a spill occurs, immediately unplug the projector and have it serviced

by a qualified service technician.

4.3 Servicing

Do not attempt to service the projector yourself. All servicing must be performed by

CHRISTIE accredited service technicians.

Use replacement parts that are manufacturer-approved only. Use of any other part other than the ones

specified by the manufacturer can result in fire, electric shock or risk of personal injury and irreparable

equipment damage.

Never service the projector while it is still plugged in. There are exposed voltages that

could cause severe physical injuries and possibly death. Always unplug the projector and wait 2 minutes

to allow the capacitors on the power supply to discharge before removing the projector’s covers.

If any of these conditions exist, immediately unplug the projector from the power outlet and ask a qualified

service technician to look at it.

• The power cord is damaged.

• The internal cooling fans do not turn on when the projector is first powered up.

• Liquid is spilled into the projector.

• The projector is exposed to excessive moisture.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 47