Christie RPMX-D132U Setup Guide download pdf (Page 16)

2-2 RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide

020-100246-02 Rev. 1 (10-2010)

Section 2: Installation and Setup

Remove the lock screw located on the mechanical lamp changer, see Figure 2-2. This screw is used for

shipping purposes only and must be removed prior to turning the projector on.

Failure to do so can result in

projector damage.

Step 2 Modifying projector configuration (if required)

To use your projector for lens-horizontal projection then you must change its configuration. The L-shaped

bracket and M6 screws shipped with the projector are needed to complete this configuration change.

1. Unplug projector from AC.

2. Disconnect all cables between the light engine and electronics module. All disconnects must be made on

the light engine side.

3. Remove the (6) M4 screws securing the light engine module to the 6-axis adjuster, see

Figure 2-3.

4. Lift the light engine off the adjuster and set aside.

5. Align the shorter end of the L-shaped bracket with the mounting holes in the adjuster base, as shown in

Figure 2-4.

FIGURE 2-2 REMOVE LAMP CHANGER LOCK SCREW

FIGURE 2-3 LOOSEN LIGHT ENGINE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 16