Christie RPMX-D132U Setup Guide download pdf (Page 23)

Section 2: Installation and Setup

RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 2-9

020-100246-02 Rev. 1 (10-2010)

NOTES:

1) See

Section 6 Specifications for details regarding compatible inputs.

2) Use only high quality shielded cables only for all connections.

FIGURE 2-11 INPUT PANEL

RGB signals (5 BNCs)

INPUT 1 has 5 BNCs for connecting a variety of sources. A typical connection would be to an RGB source such

as a PC, Mac, Sun, SGI and others. This projector supports multiple sync types: sync-on-green, composite

sync, and separate H & V syncs.

Connect the

SYNC BNC input(s). H & V syncs may be connected in any order, the projector will auto detect

them. Then connect the red, green and blue source outputs to the

RED, GREEN, and BLUE BNCs. If the source

uses sync-on-green, only the red, green, and blue connections are required. If the source provides a composite

sync output, connect it to the

SYNC input labeled HOR/COMP. If the source provides separate horizontal and

vertical sync outputs, connect horizontal sync to the

SYNC input labeled HOR/COMP and connect vertical sync

SYNC input labeled VERT. See Figure 2-12.

NOTES:1)Depending on the source, you may need a custom adapter cable with BNC connectors at the

projector end and a different type of connector at the other (such as a 15-pin "D" connector for some computer

sources). Contact your dealer for details.

2) If the projector fails to recognize a signal as an RGB signal, specify the Color Space option within the

Image Settings menu. Refer to user manual.

3) To connect YPbPr signals–such as from DVDs or analog HDTV sources–to INPUT 1, use the red, green and

blue BNCs as described in YPbPr Signals (below).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 23