Christie CP 2210 User Manual download pdf (Page 57)

Section 6: Projector Menus

CP2210 User Manual 6-3

020-100410-07 Rev. 1 (01-2012)

4: Power

Power OFF Power ON

Turns the projector on or off. Press off to place the projector in stand-by mode.

To prevent accidental activation, you must press and hold the on or off buttons.

A message displays in the title bar when the projector turns on or off.

5: Lamp

Lamp OFF Lamp ON

Turns the lamp on or off. To prevent accidental activation, you must press and

hold the on or off buttons. A boot delay occurs if you select lamp on before

pressing power on.

6: Douser

Douser Closed Douser Opened

Opens or closes the douser.

7: Aux Lens

Aux Lens OUT Aux Lens IN

Engages or disengages the auxiliary lens. If the auxiliary lens mount is not

installed, the Aux Lens buttons are disabled. Engaging the auxiliary lens

temporarily overrides the position settings defined in the Config 1 channel.

8: Lens Adjust Controls the Intelligent Lens System (ILS) lens motors. Press to open the ILS

Adjust window. If the Intelligent Lens System is not installed, the Lens Adjust

button is not available.

9: Test Patterns

Disable Select Test Pattern

Selects or disables test patterns. Press Select Test Pattern to open the Preferred

Test Patterns window.

10: Operational Status Displays the status of projector functions including the Projector Intelligence

Board (PIB), TI Electronics the Integrated Cinema Processor Board (ICP), Link

Decrypter (LD), Internal Media Block (IMB), Standby Power, Main Power, Run,

and Marriage. A green LED indicates the system is functioning correctly. A red

LED indicates a critical error that you must correct. Click the status LED to open

the Status window and resolve issues.

Control Description

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 163 164

No comments

Christie CP 2210 User Manual Page 57