Christie RPMX-D132U Setup Guide download pdf (Page 29)

Section 2: Installation and Setup

RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 2-15

020-100246-02 Rev. 1 (10-2010)

Communication parameters such as baud rate must be set to match the particular controlling device before

connecting as a network—refer to the documentation that came with your controlling device in order to

determine the proper baud rate. Refer to the user manual if you need help changing the projector baud rate. Set

the Network Routing to “RS-232 and RS-422 Joined” to reach all projectors.

NOTES: 1) To avoid damage, connect only properly wired serial communication cables. 2) Each RS-232

communication cable must be no more than 25 feet in length. Use high quality cables

2.3.5 Etherenet Network Setup

To add one or more projectors to an Ethernet network, use standard CAT5 cable to connect each projector’s

Ethernet port to a hub belonging to the network. A controller or PC must also be connected to the hub. See

Figure 2-22.

FIGURE 2-21 COMMUNICATING THROUGH A MIXED NETWORK

FIGURE 2-22 ETHERNET NETWORK

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 29