Christie RPMX-D132U Setup Guide download pdf (Page 31)

Section 2: Installation and Setup

RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 2-17

020-100246-02 Rev. 1 (10-2010)

To isolate just RS-422 communications, select “RS-232 and Ethernet Joined”. In Figure 2-23, only projector

#3 will respond to the RS422 controller. To isolate just Ethernet communications, select “RS-232 and RS-422

Joined”—only projector #1 will respond via Ethernet.

2.3.8 System Integration GPIO Connector

The GPIO connector on the input panel can be used to provide a method of interfacing a wide range of external

I/O devices to the projector.

Refer to user manual for complete details on pin configuration and how to program the various pins on the

connector.

2.4 Power Connection

WARNINGS

Do not attempt operation if the AC supply and cord are not within the specified voltage

and power range.

The North American rated line cord is provided with this projector. For all other regions,

ensure that you are using a line cord, power plug and socket that meet the appropriate

rating standards.

Do not use a line cord that has been damaged.

2.4.1 Connecting the projector to AC

Plug an appropriately rate line cord to the AC receptacle located on the electronics module and the 3-pronged

end into a grounded AC outlet.

FIGURE 2-23 ALL JOINED

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 59 60

No comments

Christie RPMX-D132U Setup Guide Page 31