Christie CP2000-M Setup Guide download pdf (Page 13)

Section 2: Basic Operation

CP2000-M/MR Setup Guide 2-5

020-100205-03 Rev. 1 (05/09)

2.3 POWERING DOWN THE PROJECTOR

NOTICE: Once the projector is powered down, the fans continue to run for approximately 15 minutes

to ensure the projector and lamp have sufficiently cooled, at which point the fans automatically shut-

off. To avoid thermal stress that can lead to premature lamp failure, never unplug the line cord while

the fans are running and never unplug to power down.

1. From the CDP, press

LAMP OFF. In this state the projector is still in POWER ON mode, which

allows for fast lamp ON response, if needed.

2. At the CDP, press

POWER OFF. The lamp powers OFF first, then the projector automatically enters

a COOL DOWN mode where the fans and electronics remain ON for 15 minutes. After this cool

down period, the projector enters STANDBY mode, and all fans and most electronics power down.

3. If servicing or removing any projector cover, disconnect AC.

2.3.1 Projector Power States

Table 2.1 identifies what occurs when any of the CDPs Power and Lamp keys are selected during the

4 main power states. NOTES: 1) The green status LED flashes while the yellow LED is ON steady

during “Boot Delay”. 2) Both green and yellow status LEDs flash during “Cool Down”. 3) To ensu re

activation of the CDP Power or Lamp keys, press firmly for 1/2 second.

2.4 USING THE CONTROL DISPLAY PANEL (CDP)

In most cases, the CDP is the primary interface with the projector. For a general overview, refer to 3.3

(Optional) Mount the Control Display Panel. For more complex setup and diagnostic controls, refer to

2.10

Using the Web User Interface.

2.4.1 Guidelines for Using the CDP

• Press keys one-at-a time; there are no simultaneous key combinations required or allowed.

• Pause briefly between key presses to allow the projector to respond to the previous action.

• Hold the navigation keys for continuous adjustment or movement in 1 direction.

• If no key is pressed within 5 minutes while in a menu, the system returns to presentation level. If

editing text or entering a numerical value, the entry is also lost.

• Press E

XIT once to cancel a selection or go back 1 level in the menu.

Table 2.1 Projector Status when any CDP Lamp or Power Key Selected

Projector’s Current State:

Standby Power Mode Power ON / Lamp OFF Power ON / Lamp ON Cooling Down Mode

Power ON To full power ON (boot delay) No action No action Once the projector has

cooled down it remains in full

power mode.

Power OFF No action Power OFF (immediately) To cool down mode, after

15 minutes goes into

STANDBY mode.

Once the projector has

cooled down it goes into

STANDBY mode.

Lamp ON To power ON and lamp ON

(boot delay)

To lamp ON (immediately) No action To lamp ON (immediately)

Lamp OFF No action No action Lamp OFF (immediately) No action

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 73 74

Comments to this Manuals

No comments

Christie CP2000-M Setup Guide Page 13

Comments to this Manuals

Related products and manuals for Projectors Christie CP2000-M