Christie CP2000-M Setup Guide download pdf (Page 73)

Section 7: Specifications

CP2000-M/MR User Manual 6-3

020-100205-03 Rev. 1 (05/09)

6.3 POWER REQUIREMENTS

6.3.1 Standard Mode (uses line cord provided)

Voltage Range: 200 - 240 VAC

Line Frequency: 50 Hz - 60 Hz nominal

Inrush Current: < 85 A max.

Current Consumption: 16 A max. (at 200 VAC)

Power Consumption: 3200 W max.

Current Rating of AC Input: IEC-320-C19/20A (required by regulatory)

Line Cord Plug Type NEMA 6-20P

6.3.2 UPS (Uninterruptible Power Supply) Mode

Activation Discrete switch above power inlet cord(s)

UPS Inlet Connector IEC-320-C13/10A, 240VAC

(rating for powering main electronics on projector)

Inlet Rating 100-240VAC, 8A (refer to license label)

Lamp Power Supply Inlet Rating

(also required) IEC-320-C19/20A (required by regulatory)

6.4 LAMPS

Type CDXL-20SD, Xenon Short Arc Lamp

Power (software adjustable) 1000W min. - 2000W nom. - 2100W max.

Average Life (See Notes 1, 2) 1000 hours @ 2000W

Warm-up time to full brightness 20 minutes max.

Wait time between lamp strikes (see Note 3) 2 minutes min.

Type CDXL-18SD, Xenon Short Arc Lamp

Power (software adjustable) 1000W min. - 1800W nom. - 1980W max.

Average Life ( See Notes 1, 2) 1500 hours @ 1800W

Warm-up time to full brightness 20 minutes max.

Wait time between lamp strikes (see Note 3)

NOTES: 1) Based on use at nominal rated power; operating at greater than nominal power reduces

lamp life. 2) End of life is defined as the point where the amount of flicker is above the manufacturer’s

threshold (1.2V); or the lamp fails to ignite 3 out of 5 successive attempts; or brightness is <50% of

initial brightness. Duty cycle 2 hours ON/0.5 hours OFF. 3) Hot re-strike (less than the minimum time

between strikes) reduces lamp life; therefore it is strongly NOT recommended.

1 2 ... 68 69 70 71 72 73 74

No comments

Christie CP2000-M Setup Guide Page 73