Christie CP2000-M Setup Guide download pdf (Page 49)

Section 3: Installation & Setup

CP2000-M/MR Setup Guide 3-7

020-100205-03 Rev. 1 (05/09)

3.7 INSTALL LAMP

NOTICE: The lamp does not come installed in CP2000-M/MR projectors (119-001101-02 or higher,

119-002103-02 or higher).

1. Open rear access door. Using the security key provided, open the rear door to access the projector

components. The door mechanism includes a safety interlock switch, which turns lamp power OFF

and prevents it from being turned ON when the door is open. The interlock wiring connects

directly to the ballast. WARNING! DO NOT place heavy objects on the open rear access door.

2. Open internal lamp door. Manually turn the two thumbscrews on the internal lamp door counter-

clockwise.

3. Install the lamp. Refer to, 4.1 Lamp Replacement, on page 4-1

for lamp installation

instructions. Observe all warnings, and wear protective clothing and shielding.

DANGER

Only personnel trained specifically by Christie on lamp replacement and

lamp safety may handle the lamp. High-pressure lamp may explode if

improperly handled. Always wear Christie approved protective safety

clothing whenever internal lamp door is open or while handling the

lamp.

CAUTION

Auto LampLOC™ must be run any time the lamp is removed (inspected

or changed).

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 73 74

No comments

Christie CP2000-M Setup Guide Page 49