Christie CP2000-M Setup Guide download pdf (Page 26)

2-18 CP2000-M/MR Setup Guide

020-100205-03 Rev. 1 (05/09)

Section 2: Basic Operation

To enable ILS:

1. From the Main menu select 1 of

the available channels.

2. Enable Test Patterns to bring up a

test pattern.

3. Select the ILS button from the

Main menu to launch the ILS

screen.

 Select Automatic ILS to

automatically apply the per

channel settings.

To edit active channel ILS settings:

1. Ensure Automatic ILS is checked.

2. Adjust the focus, horizontal (X) and vertical (Y) offset or zoom one step at a time by clicking the

applicable button or hold the button down for continuous movement. If you hold a cutton down, a

pending message will display ntil you release the button. NOTE: This over-writes the intelligent

lens system settings.

To temporarily alter the active channel ILS settings:

1. De-select the Automatic ILS checkbox.

2. Adjus the focus, horizontal (X) and vertical (Y) offset, and zoom. Note: This does not over-write

the system settings for the ILS.

3. To revert back to the ILS settings, check Automatic ILS.

Start Features or PresentationsTo start a different feature or presentation, click its corresponding

display Channel button. NOTE: By clicking a channel button, test patterns and automatically turned

OFF to present show content.

FIGURE 2-10 INTELLIGENT LENS SYSTEM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 73 74

No comments

Christie CP2000-M Setup Guide Page 26