Christie CP2000-M User Manual download pdf (Page 33)

2-16 CP2000-SB User Manual

020-100162-04 Rev. 1 (05-2009)

Section 2: Installation & Setup

2.2 Installing and Connecting Sources

Depending on site requirements, cinema servers such as digital media storage devices or non-cinema sources

such as PCs either reside outside of the projector, or are rack-mounted directly in the rear of the CP. They must

not interfere with CP operation.

Regardless of their mounting location, sources must connect to one of four ports on the Communication and

Source Connection Panel located on the underside of the projection head. They are typically connected as part

of projector installation. Once made, these connections are inaccessible from the outside of a locked projector

and can be considered secure and permanent. Changing or adding a source connection requires access via the

locked CP pedestal. NOTE: To maintain radiated emissions compliance, do not connect I/0 cables to the

projector without connecting the source or receiver at the other end.

IF EXTERNAL

Source/server cabling routes through the pedestal toe and up to the underside of the projection head. Limit

cable length to 300 feet or less. Connect power externally or within the projector. See Figure 2-23 and Figure

2-24 (shown are models with internal outlet for North America, etc.). NOTE: The DVI ports shown in Figure

2-24 are single-link ports for single-link cable/connectors only. Connect two independent sources, or connect

the Cine-IPM 2K to both ports for 10-bit processing. Using this pair of ports as a dual-link pair requires a

special adapter (not available).

Figure 2-23 Connecting an External Cinema Server/Source

Figure 2-24 Connecting an External Non-Cinema (DVI) Source

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 204 205

No comments

Christie CP2000-M User Manual Page 33