Christie CP2000-M User Manual download pdf (Page 65)

3-18 CP2000-SB User Manual

020-100162-04 Rev. 1 (05-2009)

Section 3: Operation

3.5.4 TPC Custom Menu

NOTE: Password-protected; Requires Advanced, Admin, or Installer rights.

The TPC's five Custom menus enable installers (service), administrators or advanced users to tailor projector

processing as they wish for any type of incoming source, including 3D material, and collect these settings into

a unique channel that any user can select at the Main menu. Up to 32 channels can be defined.

SAVING OR DELETING: Changes in the Custom menu are saved when you leave the menu. Or, to delete

one or more channels, use the trash bin Delete button-note a caution dialog box will appear first.

Custom: Page-1

and Page-2

These two menus consist of numerous display settings that can be adjusted as desired, then defined collectively

as a custom setup or channel. Each defined channel then appears as a button on the Main menu where any user

can select it, providing a reliable way to quickly and correctly change the on-screen display to suit the source

content. Alternatively, if a pre-defined Projector Configuration File (PCF) has been supplied with distributed

content (rare) and the Use PCF checkbox checked, those Custom options which are already defined in the

PCF (Source, Target Color, Color Space, Gamma and LUT-CLUT) disappear from the Custom menus and are

protected from further modification. The channel defined in such a case will thus be based on 1) the display

settings in the supplied PCF and 2) the remaining Custom parameters that are not contained in a PCF: the

physical location of the input connection (such as a cinema port or DVI port), the screen format, data format,

and processing path.

OTHER

SSM Communication Error Check cabling. Cycle projector power for a normal start-up. Check LEDs on card cage boards,

which can indicate a light engine problem instead. Check LVPS/Processor voltages. Also, if

shutter or lamp are functioning normally, SSM likely OK.

C Communication Error There may be a power problem with the main electronics (I

C). Check LVPS/Proc. voltage

adjustments.

LENS MOUNT

A communications error with the ILS motor

control board has occurred. Please ensure

that all cabling is correctly connected.

Check cabling. Cycle projector power for a normal start-up.

ILS Motor Control Board - Sensor Failure This error will only be detected on a lens reset or lens calibrate. Check the sensors. It is cleared

by cycling the projector power or performing a lens reset.

ILS Motor Control Board - In Boot/Program

Mode

If this message remains for longer than 4 seconds, try re-powering the TPC or upgrading the

MCB software.

ILS Motor Control Board - Main Code CRC Upgrade MCB software.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 204 205

No comments

Christie CP2000-M User Manual Page 65