Christie CP2000-X User Manual download pdf (Page 109)

Section 5

Non-cinema Operation

CP2000-X User Manual 5-1

020-100031-01 Rev . 1 (03-2009)

This section explains how to display “alternative content” originating from a standard

definition or high definition non-cinema source such as a PC or other graphics

devices, or from Christie’s Cine-IPM 2K. Such a source routes to a DVI (Digital

Visual Interface) port in the CP2000-X projection head, and can bypass cinema

processing when necessary.

Make sure your non-cinema DVI source is

connected to

DVI-1 or DVI-2 at the underside of the

CP2000-X projection head (Figure 5.1). These

connections are typically made at the time of

projector installation.

NOTES: 1) You must first remove the access panel

located on the underside of the projector near the

air filter—see Figure 5.1. Drill an exit hole or

leave the panel off. 2) For details about

connecting Christie’s Cine-IPM 2K, refer to the

Cine-IPM 2K User’s Manual

supplied with the

device.

Each DVI port accepts and will auto-detect the

progressive-scan digital RGB sources listed in

Table 5.1, displaying most of them in their

original incoming format. Note that the projector

cannot scale DVI signals over 48 Hz to a different

size and/or aspect ratio.

Note that each DVI port is a single-link port for a

single-link cable/connector only. Using this pair

of ports as a higher-bandwidth dual-link or twin-

link pair requires additional hardware and is not

currently supported (see Figure 5.2).

5.1 Compatible

Non-cinema

Sources

Figure 5.1. Non-cinema DVI

Source Connection

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 163 164

No comments

Christie CP2000-X User Manual Page 109