Christie CP2000-X User Manual download pdf (Page 22)

INSTALLATION & SETUP

2-14 CP2000-X User Manual

020-100031-01 Rev. 1 (03-2009)

Adjusting the Feet

For installations on a floor or suitable

supporting structure, a single projection head

should rest firmly on its feet. There is no

need for the FredFrame



unless stacking

with another projector, or unless you decide

to rig and fly the projector.

To adjust the height and level of the

projector, extend or retract the feet by

rotating them. See Figure2.15.

Tilting

In an ideal installation, the lens surface is

parallel to the screen. This orientation

helps to ensure optimized lens

performance with minimal offset. If this

position is not possible (such as when the

projector is significantly higher than the

center of the screen), rely on offset to

compensate. To avoid keystoned images,

keep the projector as orthogonal to the

screen as possible (see right).

Check with theatre personnel for the

degree of screen tilt, or measure this

incline with a protractor at the screen.

Then TILT the projector to closely match

this screen tilt angle. For any installation,

you can tilt the front end of the projector

up or down as much as 15 (see right).

Likewise, side-to-side tilt must not

exceed 15 (see Figure 2.19. below). This

limit ensures safe lamp operation and

proper position of the liquid cooling

reservoir in the projector.

WARNING

Tilt only as shown.

Figure 2.16. Adjusting the Feet

Tilting and Special



Orientations

Figure 2.17. Tilt Projector to

Match Screen

Figure 2.18. Maximum Tilt

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 163 164

Comments to this Manuals

No comments