Christie CP2000-X User Manual download pdf (Page 33)

INSTALLATION AND SETUP

CP2000-X User Manual 2-25

020-100031-01 Rev . 1 (03-2009)

Do not connect the ballast to AC unless the projection head and ballast are already

connected to each other, otherwise the exposed live ends of the heavy ballast cables

could be a serious hazard.

WARNING

Connect the ballast to the projector FIRST, and then connect to AC.

AC power levels vary from

region to region throughout

the world, with 400 VAC

common in some countries

(such as those in Europe and

Asia), and 200 AC common

elsewhere (such as in North

America and Japan). To

accommodate both

possibilities, the ballast

includes an internal Input

Power Range Switch for

toggling to the level of AC

available at the installation

site, i.e. either 200 or 400

VAC. The line cord plug

must also match.

From the factory, the ballast

switch and line cord are both

set for 200 VAC use.

Used/rented ballasts shipped

from other installation sites

may be set to either,

depending on where they

were last used—check the

status of the line cord plug

and switch before attempting

to connect to AC. See

instructions below (Figure

2.29.).

WARNING

Check the plug and internal switch before connecting to

AC. Qualified electrical technician required.

1. A visual inspection of the plug can indicate 200 or 400 VAC status. Modify as

necessary for your site—as a delta load with safety ground, the plug has no

neutral.

5. Remove the ballast cover to access and read the Input Power Range Switch.

6. Toggle the switch left for use with 200 VAC supplies, or toggle right for 400

VAC supplies.

7. Attach the ground lug to Earth Ground.

2.7 Connecting the

Ballast

Configuring the Ballast



For Incomin

Figure 2.29. Setting Up the 7kW Ballast

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 163 164

Comments to this Manuals

No comments

Christie CP2000-X User Manual Page 33

Comments to this Manuals

Related products and manuals for Projectors Christie CP2000-X