Christie CP2000-X User Manual download pdf (Page 29)

INSTALLATION AND SETUP

CP2000-X User Manual 2-21

020-100031-01 Rev . 1 (03-2009)

ADD EXTRACTOR: See Figure 2.25.

Connect the other end of the duct to the

Christie heat extractor/blower, twisting to

secure “flaps” over pins on the fan. Make

sure that the grille

end of the fan faces

down

. For longer exhaust runs at your

site, add extractors/boosters as

necessary—the vane switch at the

projector’s top exit port will trigger a

projector shutdown if the airflow is

inadequate. To prevent possible transfer

of fan vibration to the image, do not

mount the extractor directly on the

projector—include at least 6” of duct.

WARNING

Do not exceed 6-ft. duct length without

adding additional extractors.

To suspend the projector/fan assembly,

always use appropriate rigging hardware

and secure to adequate support structures

at your site.

 The Christie 6-ft. duct-with-fan

weighs approximately 22 lb.

 The Christie 6-in. duct-with-fan weighs approximately 15 lb.

Use third-party extractors only if the minimum of 600 CFM airflow can be

maintained.

SECURE SAFETY CABLES: Three safety cables are provided, and are all mandatory

whenever the fan/duct assembly is suspended. These cables prevent components from

falling if your rigging equipment fails. Figure 2.26 shows the safety cable required

between the cooling assembly and projector in any installation, flown or not. Attach

remaining safety cables between the 1) duct and fan, and 2) fan and supporting

structure.

Figure 2.25. Securing Extractor to

Duct

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 163 164

No comments

Christie CP2000-X User Manual Page 29