Christie CP2000-X User Manual download pdf (Page 122)

MAINTENANCE

6-10 CP2000-X User Manual

020-100031-01 Rev. 1 (03-2009)

Check Leads

Make sure that the anode (+) lead between lamp and igniter is well away from any

projector metal such as the reflector or firewall.

WARNING

Leads too close to metal parts will cause arcing during

starting pulse. This is a SAFETY HAZARD,

and the lamp may not ignite.

Close cooling compartment and lamp door

The projector will not operate unless the louvered door is locked shut.

Record the LAMP INSTALLED

With a blue dot label or dry-erase pen, mark the lamp door’s LAMP INSTALLED

label (Figure 6.3) to indicate the size of the newly installed lamp — 2.0, 3.0, 4.5, or

6.0 kW. A supply of blue dot labels is secured inside the front cover of this manual.

Figure 6.3. Always Mark the “Lamp Installed” Label

(EXAMPLE)

Re-connect to AC and turn breaker to ON

Re-connect the projection head and the ballast to AC (see 2.1, Quick Setup), then set

the ballast breaker to

ON.

Set proper LAMP TYPE (power)

NOTE: Skip this step if your new lamp is the same size as the old lamp—the Lamp

Type will still be correct in the Install menu.

IMPORTANT: Requires access to TPC Install: Lamp menu (authorized access only).

If your new lamp is larger or smaller than the old lamp, record the new lamp type

(2.0, 3.0, 4.5 or 6.0 kW) in the Touch Panel Controller’s Install: Lamp menu before

igniting the new lamp. This setting establishes the proper range of power available

for the installed lamp, ensuring that the new lamp is neither underpowered nor over-

driven.

STEP 9 

STEP 10 

STEP 11 

STEP 12



STEP 13 

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 163 164

No comments

Christie CP2000-X User Manual Page 122