Christie CP2000-X User Manual download pdf (Page 27)

INSTALLATION AND SETUP

CP2000-X User Manual 2-19

020-100031-01 Rev . 1 (03-2009)

1. Check lamp cradle (anode end) location for your lamp

 For 4.5 or 6.0 kW lamps, the lamp

cradle must be as far forward as

possible (factory default).

 For 2.0 or 3.0 kW lamps, move the

cradle to the rear position, i.e.,

approximately 1” closer to the

reflector. See Figure 2.22.

2. Install Lamp

See 6.4, Replacing the Lamp & Filter,

Steps 7-11. Observe all warnings, and wear

protective clothing and shielding.

Don’t forget to properly mark the “Lamp

Installed” label on the lamp door to

indicate current lamp size. Also set the

Lamp Type in the TPC Lamp menu

(service/installer login required) before

turning on the projector.

Extractor Fan and Duct

For any CP2000-X with any lamp, install

the Christie extractor fan and duct to pull

warm exhaust air from the projector at a

minimum rate of 450 CFM (for 2 or 3 kW

lamps) or 600 CFM (for 4.5 kW or higher lamps). Use either the 6-in. or the 6-ft.

duct in one of the configurations shown in Figure 2.23. below:

Figure 2.23. Extractor Fan Configurations

(MANDATORY SAFETY CABLING NOT SHOWN)

Figure 2.22. Move cradle back

for 2.0 or 3.0 kW lamps

Cooling



1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 163 164

No comments

Christie CP2000-X User Manual Page 27