Section 2: Installation & Setup
2-4 CP2000-X SETUP GUIDE
020-100059-01 Rev 1. (03/08)
HEAD-TO-AC: Connect the
Christie-supplied IEC 320
(220V) 15-amp line cord to a
single phase 208V AC
supply. Do not substitute
other cords. Input power
required is 200 - 240 VAC
(±10%), 50 to 60 Hz @ 3
amps for 208 V.
WARNING
Do not attempt operation if
the AC level is not within
the specified voltage and
power range for the
projection head
(180-265 AC).
EXTRACTOR: Also plug the extractor fan into the projector. See 2.4, Installing a
Lens, Lamp, & Cooling
At this point, the projection head is ready for use:
• The voltmeter should display the incoming voltage
•
PROJ. STATUS light should be green
• Light engine compartment fans near the front should be running
• Remainder of projection head will be off
Set Lamp Type and Cable Length
NOTE: Service/installer required.
WARNING
Explosion hazard. Keep the projection head OFF until you
have defined which lamp type is installed.
Figure 2.5 Connecting Projection Head
to AC Supply
STEP 6
Comments to this Manuals