Section 3
Basic Operation
CP2000-X SETUP GUIDE 3-1
020-100059-01 Rev 1. (03/08)
This section describes basic projector operation once it is properly installed, by a
qualified service technician, as described in Section 2, Installation and Setup.
Refer to the User’s Manual for a description of the various components identified
in Figure 3.1.
Figure 3.1 Basic Projector and Related Components
NOTE: This is a typical manual power-up procedure. Cinema installations may
include an automation system for controlling projector start-up and lamp
ignition in conjunction with other variables such as lighting, audio, etc
WARNINGS
Do not attempt operation if the AC supply is not within the
specified voltage range.
1. Make sure that ballast is properly configured for the AC at your site, and that
it is connected via 4 cables to the projection head. See 2.7, Connecting the
Ballast.
3.1 Projector
Basics
Com
onents/Features h
3.2 Power-up
Procedure
Comments to this Manuals