Section 4: Maintenance
CP2000-X SETUP GUIDE 4-9
020-100034-01 Rev 1. (03/08)
Figure 4.1 Install Lamp
2. Rest the anode (+) end of the lamp on the lamp cradle as shown in Figure
4.1, right, and slip the positive lamp connector over the bulb end.
3. Tighten setscrews in both negative and positive lamp connectors (Figure
4.2).
Figure 4.2 Secure Lamp at cathode (–) and anode (+) connectors
IMPORTANT: Proper electrical contact prevents resistance in the lamp
connectors.
If you accidentally touch the quartz body of the lamp with your bare hands, clean
it as described in 4.3, Maintenance and Cleaning.
Comments to this Manuals