Christie CP2000-X Setup Guide download pdf (Page 32)

Section 2: Installation & Setup

2-24 CP2000-X SETUP GUIDE

020-100059-01 Rev 1. (03/08)

When the ballast has been properly configured (see 2.7, Connecting the Ballast)

and connected to the projection head, connect its integral line cord to AC. Then:

SET LAMP TYPE:

WARNING

Qualified Service Technician/Installer is required.

HAZARD

Explosion hazard. Keep the projection head OFF

until you have defined which lamp type is installed.

Before powering up

the projector and

igniting the lamp, the

installer must define,

in projector memory,

which size lamp is

installed; otherwise

you risk severely

overdriving or

underdriving a lamp.

At the TPC, go to the

Admin: Lamp menu

(password required).

Enter the size of the

lamp currently

installed in the

projector (factory

default = 2.0 kW).

See User’s Manual -

Section 3, Operation

if you need help using the TPC menus. Also record the lamp type on the “Lamp

Installed” label attached to the lamp door.

SET CABLE LENGTH: Still in the Admin: Lamp menu (see Figure 2.30), use the

“Cable Length (m)” text box to record the length of high-voltage DC cables

connected between your lamp ballast and projection head. This value regulates

the voltage drop that occurs over distance, and ensures that adequate voltage

reaches the lamp. This setting may have to be changed from its last use,

particularly in a projector rented for temporary installation. Adjustment range is

2-30m (6½-100 ft.).

POWER-UP: Power up the CP2000-X system as described in User’s Manual - 3.2

Power-up Procedure.

2.8 Initial Power-

Figure 2.30 Lamp Type and Cable Length

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 63 64

Comments to this Manuals

No comments

Christie CP2000-X Setup Guide Page 32

Comments to this Manuals

Related products and manuals for Projectors Christie CP2000-X