Christie CP2000-X Setup Guide download pdf (Page 30)

Section 2: Installation & Setup

2-22 CP2000-X SETUP GUIDE

020-100059-01 Rev 1. (03/08)

related equipment. These system connections are typically done at time of

installation, but are fully accessible and can be changed at any time. In rare cases,

serial and/or Ethernet links are needed only during installation, and are

disconnected afterwards.

Connect your devices to the Communications and Source Connection Panel at

the rear of the projection head.

Figure 2.28 Communication Links with Projector

TPC: Connect the TPC cable to the 6-pin XLR connector. This connector then

routes to an internal 5-port Ethernet hub connected to the projector’s main

processing electronics.

PC/LAPTOP, SERVER OR NETWORK: To communicate with the CP2000-X from a

computer, server or an existing network, connect the equipment to

ETHERNET A

or ETHERNET B. Both ports route to the 5-port Ethernet hub connected to the

projector’s main processing electronics. If Ethernet is not available at your site,

connect a standard serial cable to the

RS232 port instead—note this

communication link is acceptable for using a PC/laptop to run Christie’s DCP

Librarian or to download new software, but is too slow for server

communications and does not support ASCII messaging to the TPC (which

requires Ethernet).

HAZARD

Do not connect the ballast to AC unless the projection head

and ballast are already connected to each other, otherwise

2.7 Connecting the

Ballast

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 63 64

No comments

Christie CP2000-X Setup Guide Page 30