Christie CP2000-X Setup Guide download pdf (Page 36)

Section 2: Installation & Setup

2-28 CP2000-X SETUP GUIDE

020-100059-01 Rev 1. (03/08)

• If focus on the paper

improves, this indicates

that the right side of the

image is focusing in front

of the screen. See Figure

2.37.

• If focus on the paper

worsens, this indicates that

the right side of the image

is focusing behind

the

screen.

GOAL: If the image comes into

focus on both sides

simultaneously, left/right

boresight is fine—skip to Step

3. Adjust the horizontal boresight bolt

(Figure 2.38) as necessary to direct or

“aim” the lens toward the side of the

image which focused too close to the

lens. When both sides appear equally

blurry, re-focus on the left side of the

screen.

4. Adjust horizontal offset to re-center the

image on the screen.

5. Repeat Steps 4 and 5 until both sides of

the image are well focused.

6. Adjust the “hold” screw to lock in place,

and check boresight again.

1. When left/right boresight

is complete, focus the

image at the top edge of

the screen (Figure 2.39.).

If the bottom remains

blurry while the top edge

is focused, refer back to

Step 2 but use a paper at

the bottom of the screen to

determine whether the

bottom of the image is

focused in front of

the

screen or behind

the screen. If the bottom is well focused, skip to Step 11.

Figure 2.37 Example of Poor Left/Right

Boresight

Figure 2.38 Adjust

L/R Boresight

Figure 2.39 Adjust Top Focus

Adjust Top/Bottom h

Boresi

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 63 64

Comments to this Manuals

No comments

Christie CP2000-X Setup Guide Page 36

Comments to this Manuals

Related products and manuals for Projectors Christie CP2000-X