Status Read Commands
8-30 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information
020-000046-02 Rev 2 (07-2011)
8.9.11 CF_PJPINCODE Command
Command
“CF_PJPINCODE_%1” [CR]
%1
“0000 – 9999” - Directly specify PJ PIN code
Detail
Enter PIN code to cancel PIN code lock (Available only in the normal
Power ON status) PIN code can not be changed. (Only PIN code lock
is canceled.)
*When PIN code Lock is enabled:
PIN code is matched - Command is valid (Acceptable)
PIN code is mismatched - Command is invalid (Error code “102”)
PIN code is beyond %1 available range - Command is invalid
(Error code “?”)
When PIN code lock is canceled:
PIN code is within %1 range - Command is valid (Acceptable)
PIN code is out of %1 range - Command is invalid (Error code is
102)
This command is only valid when “PJ PIN code” dialog is displayed
to enter PIN code after Power is ON and Countdown is completed.
When PIN code lock is set to “On1”, it needs to send this command
every time the projector is turned on.
Response Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.9.12 CF_FILH Command
Command
“CF_FILH_%1” [CR]
%1
“RST” - Reset Filter used time
Detail
Reset used time for filter of projector
Response Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.9.13 CF_FILTIMER Command
Command
“CF_FILTIMER_%1” [CR]
%1
“0400” - Set 400 hours
“0700” - Set 700 hours
“1000” - Set 1000 hours
“OFF” - Set Off(Do not warning display)
Detail
Set time to display Filter cleaning/replacement warning on screen.
Response Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
Comments to this Manuals