Christie CP2000-M Specifications download pdf (Page 29)

Section 5: Parts and Module Replacement

CP2000-M/MR Service Booklet 2-19

020-100220-02 Rev. 1 (07/08)

9. Before the old lamp is put into its case ensure the cathode nut is placed back onto the lamp. Follow

all local safety standards for proper disposal.

INSTALLING A NEW LAMP

• Remove the cathode clamp from the lamp before removing it from

its case.

• Hold the anode end of the lamp in your left hand and angle it up

through the hole in the back of the reflector assembly. Insert your

right index and middle finger through the back front of the reflector

and guide the lamp onto the cathode holder. Be careful not to hit the

lamp against the reflector.

• Hand-tighten the cathode clamp onto the cathode end of the lamp.

• Tighten the cathode nut.

• Align the ring terminal on the anode wire with the mounting

position, ensuring the crimped side of the wire is facing out

(Figure 2-17). Tighten the anode nut.

• Ensure LampLOC™ is adjusted

2.6 LAMP COMPARTMENT

2.6.1 SAFETY SHIELD

The safety shield is positioned above the lamp

reflector and is used to block UV light.

(5 minutes)

1. Open the rear lamp door via the low security

key.

2. Use a #1 Phillips™ to loosen the 3

thumbscrews (Figure 2-18).

3. Remove the safety shield.

4. To reinstall, reverse the above steps.

FIGURE 2-17 ANODE WIRE

FIGURE 2-18 SAFETY SHIELD

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 121 122

No comments

Christie CP2000-M Specifications Page 29