Christie CP2000-M Specifications download pdf (Page 39)

Section 5: Parts and Module Replacement

CP2000-M/MR Service Booklet 2-29

020-100220-02 Rev. 1 (07/08)

7. Reverse the above steps to install the 220V AC line filter.

A/C SELECTOR SWITCH

1. Disconnect the AC power cord.

2. Unlock the rear lamp door.

3. Remove top lid. Refer to 2.5.5 Top Lid, on page 2-10

4. Remove lamp door frame skin. Refer to 2.5.11 Lamp Door Frame Skin, on page 2-14

5. Disconnect the 6 harnesses from the AC selector switch (Figure 2-31, A).

6. Use a #1 Phillips™ to remove the 2 screws securing the AC selector switch to the rear skin frame.

7. Reverse the above steps to install the AC selector switch.

2.7 CARDCAGE AND LVPS COMPARTMENT

2.7.1 CARDCAGE MODULE

The cardcage module consists of a split faceplate. When the screws are loosened the top plate can be

flipped up allowing access to all the boards except the PCM.

(30 minutes)

1. Remove top lid. Refer to 2.5.5 Top Lid,

on page 2-10.

2. Remove the 6 screws securing the high

security cover, unlock the high security

access lock, lift the lid and slide out.

3. Remove the intake duct. Refer to 2.5.12

Intake Duct, on page 2-15.

4. Use a #2 Phillips™ to loosen the 2

thumbscrews on the top of the cardcage.

5. Unclip the harness clips securing the

harnesses (Figure 2-32).

6. Disconnect the 6 light engine

communication and 3 power harnesses

from the FFIB. Refer to the Interconnect

Drawing.

7. Use a #1 Phillips™ to remove the 6

screws securing the split faceplate to the cage (2 on each side and 4 along bottom).

8. To access the Motherboard connections push from the back of the cardcage and pull on the handles

to move it out a few centimeters.

DANGER

Always wear protective safety clothing and a face shield when performing service

with the service safety shield removed (i.e., LVPS rail adjustment).

FIGURE 2-32 HARNESS CLIPS

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 121 122

No comments

Christie CP2000-M Specifications Page 39