Christie CP2000-M Specifications download pdf (Page 63)

Section 5: Parts and Module Replacement

CP2000-M/MR Service Booklet 2-53

020-100220-02 Rev. 1 (07/08)

2.8.9 SHUTTER ASSEMBLY

The shutter is attached to the light engine prism. For additional details, refer to Appendix B: Shutter

Override.

(30 minutes)

1. Remove top lid. Refer to 2.5.5 Top Lid, on page 2-10

2. Remove the 6 screws securing the high security cover, unlock the high security access lock, lift the

lid and slide out.

3. Use a #2 Phillips™ to remove the 8 screws around the light engine cover and a flat head

screwdriver to remove the 2 captive screws. Lift the cover off. NOTE: Cutouts in the cover

provide access to the captive screws.

4. Use a 2mm Allen™ key to remove the 2 hex screws securing the light dump.

5. Pull the cardcage out and disconnect the shutter from the Motherboard. Refer to the Interconnect

Drawing. NOTE: Ensure the harness clips, securing the harnesses to the top of the cardcage are

removed before pulling the cardcage out.

6. Cut the cable tie to free the shutter harness.

7. Use a #2 Phillips to remove the 2 screws securing the shutter assembly (Figure 2-66).

8. Reverse the above steps to install. NOTE: Ensure the cardcage harness clips are reinstalled.

FIGURE 2-66 REMOVE SHUTTER

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 121 122

No comments

Christie CP2000-M Specifications Page 63