Christie CP2000-M Specifications download pdf (Page 35)

Section 5: Parts and Module Replacement

CP2000-M/MR Service Booklet 2-25

020-100220-02 Rev. 1 (07/08)

2.6.7 LAMP DOOR INTERLOCK

The lamp door interlock is located on the lamp door skin, mounted to the lamp door support bar.

(20 minutes)

1. Open the rear lamp door.

2. Remove top lid. Refer to 2.5.5 Top Lid, on page 2-10

3. Disconnect the red and black leads from the lamp door interlock (Figure 2-26, A).

4. Use a #1 Phillips™ to remove the 2 screws and nuts securing the switch to the bracket (Figure 2-

26, B).

5. Reverse the above steps to reinstall.

FIGURE 2-26 LAMP DOOR INTERLOCK

2.6.8 LAMP BALLAST

The lamp ballast comes with the lamp igniter built in and is located at the rear of the projector, attached

to the base plate.

(60 minutes; includes 10 minute LampLOC™ alignment)

1. Open the rear lamp door skin.

2. Remove top lid. Refer to 2.5.5 Top Lid, on

page 2-10.

3. Remove the lamp. Refer to 2.5.14 Remove

Lamp, on page 2-18.

4. Remove the lamp blower assembly. Refer to

2.6.2 Main Blower Assembly, on page 2-20

5. Disconnect the AC power harness by pushing

in on the clip (Figure 2-27).

FIGURE 2-27 AC POWER HARNESS

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 121 122

No comments

Christie CP2000-M Specifications Page 35