Status Read Commands
8-10 LW600-LX900-LX1000 RS232 Codes-Expanded Technical Reference Information
020-000046-02 Rev 2 (07-2011)
8.5.4 CF_V-POS Command
Command
“CF_V-POS_%1” [CR]
%1
“0000-nnnn” - Directly specify setting value of Vertical Position
“nnnn” indicates maximum value, which is current (Total Line –
Display Area V) value
“UP” - Increment setting value of Vertical Position by 1
“DN” - Decrement setting value of Vertical Position by 1
Detail
Set Vertical Position value in PC signal (available only in the normal
Power ON status).
The value set by this command is not stored in the projector’s
memory. Therefore, when the power is turned to ALL OFF status,
the value returns to the original setting. (It is stored in Suspend
mode.)
Response Acceptable
“000” [CR]
Unacceptable
“101” [CR]
• When input is Video signal
• When input is no signal
8.5.5 CF_CLAMP Command
Command
“CF_CLAMP_%1” [CR]
%1
“0000-4095” - Directly specify setting value of Clamp
“UP” - Increment setting value of Clamp by 1
“DN” - Decrement setting value of Clamp by 1
Detail
Set Clamp value in PC signal (available only in the normal Power ON
status).
The value set by this command will not be stored in the projector’s
memory. Therefore, when the power is turned to ALL OFF status, the
value returns to the original setting. (It is stored in Suspend mode.)
Response Acceptable
“000” [CR]
Unacceptable
“101” [CR]
• When input is Video signal
• When input is no signal
Comments to this Manuals